ZOOM

System version 1.12 has been released. Changes in the new version are as follows.

1) Fixed a problem where the status (REC/PLAY/MUTE) of track 1 or track 4 would change inadvertently when the [ZERO] key or [STOP] key was pressed while the WAIT bar was being shown after completing an audio recording.

User Agreement

The specifications of this software and/or the contents of this document are subject to change without notice. Zoom will not bear any responsibility for use or as a result of using this software, or for any claims regarding this software or use thereof by a third party. Any unauthorized distribution, sales,lease, rental, altering or reverse engineering of this software is strictly forbidden.

*For details about how to update, please refer to "Readme.txt" included in the ZIP file.

A setup file (key mapping file) is a file for use with Mackie Control mode. It maps the control keys of the HD8 to DAW software functions. For details on use, please refer to the "Mackie Control Mode Manual Supplement".

Precautions

・Even if the DAW software does not come with a key mapping setup file but supports Mackie Control, basic functions such as panning, fader, and transport control are still possible.
・If the system software of your HD8 is version 1.11 or later, a key mapping setup file may already be loaded. In such a case, the file updating process is not required.
・In case of Cakewalk SONAR series, "Control Surface Plug-in" must be installed.

A setup file (key mapping file) is a file for use with Mackie Control mode. It maps the control keys of the HD16 to DAW software functions. For details on use, please refer to the "Mackie Control Mode Manual Supplement".

Precautions

・Even if the DAW software does not come with a key mapping setup file but supports Mackie Control, basic functions such as panning, fader, and transport control are still possible.
・If the system software of your HD8 is version 1.11 or later, a key mapping setup file may already be loaded. In such a case, the file updating process is not required.
・In case of Cakewalk SONAR series, "Control Surface Plug-in" must be installed.