Q:	How to get constant volume level when I change patch programs?

A:	You can set specific volume level for each patches using "LEVEL" knob. Then you can get constant volume level even you will change patches. Please note that "MASTER" knob is to adjust master volume which is common parameter for all patches.

Q:	What can be possible when I use optional foot switch FS01?

A:	You can switch from/to MANUAL MODE to/from PROGRAM MODE by foot. For example, you can set up clean sound for backing on manual mode, and select overdrive sound for lead phrase on program mode, then you can use FIRE amplifier as like 2 channel guitar amp.

Q:	How to adjust volume balance for CD sound from AUX IN and guitar sound?

A:	You cannot change the sound level from AUX IN. So please adjust it by output volume for CD player.

Q:	Is it possible to use FIRE amp as modeling processor, when I connect [RECORDING/PHONES] output to recording equipment?

A:	Yes, it is possible. You can record modeling amp sound directly which is not depending on a power amp ability or speaker size. When you connect [RECORDING/PHONES] out, speaker sound is muted.

Q:	Even if "MASTER" volume is turned to high position, actual sound is not big. (FIRE-30)

A:	Please check whether "POWER DAMP" switch is on. POWER DAMP function is to use in home or private room where you cannot use loud sound. Even volume is not so loud, you can get powerful drive feeling and attack feeling for high tone.