Q:	The signal from the microphone contains other sounds.

A:	The microphone will pick up ambient noise as well. Use the unit for monitoring in a quiet environment.

Q:	The signal from the microphone is distorted.

A:	When the volume is too high, the output from the speaker may be distorted, which will lead to distortion in the microphone signal. Use the MASTER knob to set the volume to a suitable position.

Q:	How to get constant volume level when I change patch programs?

A:	You can set specific volume level for each patches using "LEVEL" knob. Then you can get constant volume level even you will change patches. Please note that "MASTER" knob is to adjust master volume which is common parameter for all patches.

Q:	What can be possible when I use optional foot switch FS01?

A:	You can switch from/to MANUAL MODE to/from PROGRAM MODE by foot. For example, you can set up clean sound for backing on manual mode, and select overdrive sound for lead phrase on program mode, then you can use FIRE amplifier as like 2 channel guitar amp.

Q:	How to adjust volume balance for CD sound from AUX IN and guitar sound?

A:	You cannot change the sound level from AUX IN. So please adjust it by output volume for CD player.

Q:	Why does the FIRE-36M have two microphones?

A:	Dedicated preamplifiers are provided to produce dynamic mic sound from MIC1 and condenser mic sound from MIC2. Mixing two microphone signals with different character provides a wide range of possibilities for sound creation.

Q:	Even if "MASTER" volume is turned to high position, actual sound is not big. (FIRE-36M)

A:	Please check whether "POWER DAMP" switch is on. POWER DAMP function is to use in home or private room where you cannot use loud sound. Even volume is not so loud, you can get powerful drive feeling and attack feeling for high tone.