Q:	As output level of each programmed patch is uneven, I would like to keep them even.

A:	Please adjust "PATLVL" parameter in TOTAL module for each patch to keep the output level even. You can set up total patch level.

Q:	Is it possible to turn on/off effect modules by foot pedals?

A:	The GFX-5 has a function which you can assign each effect module to foot pedals and turn on/off each effect. This function is called "Manual Mode". Foot pedals of GFX-5 can be just like on/off switch of stomp box. Please refer to "Manual Mode"(p.19) of the operation manual.

Q:	Effects, such as "Wah" using expression pedal, do not start.

A:	Expression pedal operates also as an on/off switch for assigned effect by stepping on. Please step on ahead more strong. Refer to "Calibrating the expression pedal"(p.26-p.27) of the operation manual.

Q:	Using Sampler function, it cannot record.

A:	Please check operation, connection and output level of the playback equipment (CD player etc) of sound source for sampling. Also, input level must become too small when the connection cable is "with resistor" type. Please use "no resistor" type cable.

Q:	Even though I selected "HLDDLY" effect in REV module, the hold delay function cannot be used.

A:	While GFX-5 is in manual mode, the hold delay function cannot be used. When GFX-5 is in play mode, please set source of control for expression pedal to “PEDAL” and target of control to “REV”, using [CONTROL] and [ASSIGN] key. For details, please refer to “Using the hold delay function”(p.23-p.24) of the operation manual.

Q:	When Sampler function is turned on, MOD and REV modules are automatically turned off.

A:	Due to limitation of DSP resource, MOD and REV modules cannot be used in sampler mode.

Q:	Even though I set MINVOL parameter in TOTAL module, it doesn’t affect the minimum value of Volume pedal.

A:	Please set the R-MODE parameter to “Hi” or “Lo”. When “UP” or “dn” is selected, the variable range of volume pedal is from zero to maximum.

Q:	There is something wrong with bypassed sound.

A:	The Energize function works also in the bypass condition. Please set the "Energize" to “oF”.

Q:	Sound is unnaturally distorted.

A:	TURBO / EDGE / BOOSTER / ISOLATOR / COMP effects can amplify the input signal. When high-power guitar with active pickup is used with the above effects, unwanted distortion may occur depending on DRIVE module effect type, because of signal saturation.

Q:	Using high-gain distortion effects, noise level becomes higher.

A:	All drive effects such as overdrive, distortion, fuzz are produced by amplifying input signal. (not only ZOOM products) Therefore, a very little noise in guitar signal which comes from guitar pickup or guitar cable will be amplified together. To minimize noise level, please adjust ZNR parameter properly.

Q:	Why does the TEMPO key flash although I am not using the rhythm section?

A:	For patches where the ARRM function is enabled, the TEMPO key will always flash to indicate the patch-specific tempo that is used by the ARRM function. For details, see the section "Changing effects in real time" on pages 20 - 23 of the Operation Manual.

Q:	Is it possible to have the unit memorize the Energizer setting?

A:	No, this is not possible. The Energizer setting applies to all patches and cannot be stored. Make the setting each time as required.