|
Common Question
|
|
| A: |
When using a product
with battery, use of an alkaline battery is recommended. It
lasts long about 3 times of a manganese battery, although it
is dependent on the kind and model of battery. Moreover, in
case you use the products in the room, we recommend you to
use an optional or attached Zoom brand AC adapter. Please
note that it is possible to cause of a noise or defectives
if you use other brand's AC adaptor.
|
|
| A: |
When an AC adaptor is
used with other electric products, Ham Noise can be caused
via power lines. Please avoid combined use of the socket
with other equipments that has high power consumption, like
lighting, heating, television, etc. Also, noise may be
caused by degradation, disconnection or dirt of terminals,
for both musical instruments and cables. Please check other
equipments also.
|
|
| A: |
Please use "no
resistor" type cable. There is a "with resistor" type
conversion cables for RCA pin terminal to stereo phone jacks
that is used for the connection with home audio equipments
and studio line apparatus. When you use this type, an output
signal may drop extremely.
|
|
| A: |
A single coil pickup
tends to be theoretically influenced of other electric
equipment or lighting, and causes a noise. This is not a
problem peculiar to our products. Please separate our
products and/or shield cable from other equipments as far as
possible. Moreover, as original Zoom Noise Reduction system
"ZNR" permits you to obtain natural noise reduction by
adjusting sensitivity.
|
|
| A: |
The best sound,
frequency response or effect character, may be obtained when
connecting guitar/bass to guitar/bass effect processor.
However, even if guitar/bass effect processor will be used
with other musical instruments, VOCAL, etc., sufficient
effect can be acquired. Please adjust the various parameters
of a patch considering the sound character of the musical
instrument you use. As the product does not break down
because of the other musical instrument to connect, please
use it in comfort. Moreover, when using with a microphone,
please note that the preamplifier should be needed.
|
|
| A: |
Please adjust "Patch Level" parameter for each patch to keep the output level even. You can set up total patch level.
|
|
| A: |
Cubase LE 4 / LE 5 is an OEM product supplied by Steinberg Media Technologies GmbH. Cubase LE 4 / LE 5 operation is not covered by ZOOM Corporation support. For information on use, refer to the PDF manual or to reference books available on the market.
|
|
|
|
|
Common Question