|
RT-234
|
|
| A: |
In case of temporary mute of sound, push function key, pad 2 setting for MIX, set the level of bass track at "0". Please refer setting for function key in operation manual.
When bass track is unnecessary, play the pattern in recording mode, press the Bass Track button while pushing DELETE/ERASE key, and continue holding until the pattern looped. Bass sound is completely erased.
|
|
| A: |
When using FP-02, you are able to control the function same as the Jam Slider by foot, like opening/closing of hi-hat, change of volume and sound character.
Also when using FS-01, you can control the function same as PAD or switches by foot, like start/stop for song, trigger for Bass drum sound.
|
|
| A: |
It means that you used up the memory and you are not able to create any new data. Please eliminate unnecessary songs or patterns and make certain memory area free. As RT-234 does not have external saving media, you have to record as "Sound" of the completed song to MTR etc.
When displayed "FULL" in spite of few songs, the bar length of each pattern may be too long. Song is created combining some patterns. However, in case you create the part repeating the same pattern of drum & bass, please use one pattern. Also, the suitable bar length is less than 4 bars per pattern.
|
|
| A: |
RT-234 has no function to save the data to external media. It is necessary to record as "sound" of the completed data to MTR, DAT or MD, etc. In upper model RT-323, the data can be saved at Smart Media.
|
|
| A: |
You cannot record exact nuance when the quantise is not maximum value. On the other hand, you can record exact 16th note when quantise is "16" even timing is not accurate.
|
|
| A: |
The setup of quantise is not the optimum value. For example, when inputting 8th note, the setup of quantise should be"8". In case of 16th note, it should be "16".
|
|
| A: |
Please check if MIDI channel of the equipment is same as RT-234's channel. In addition, please refer to MIDI implementation chart at the last page of operation manual.
|
|
| A: |
When using RT-234 as MIDI sound module, drum kit is dependent on Program Change information, and it is different with the Kit chosen by RT-234 itself. In case you use RT-234 as MIDI sound module, please choose the Kit by sending Program Change information. And please refer to the table for correspondence of program change and kit in operation manual.
|
|
| A: |
No, this is not possible. The pan setting for the drum sounds is fixed.
|
|
|
|
|
Common Question