FAQ
BFX-708
BFX-708
As the volume of each programmed patch is various, I want to keep them constant.
You can set up "Patch Level" parameter for each patch, so that the volume can be kept constant even when changing a patch. The "Level" parameter of ZNR/EQ module can also be used for a volume adjustment.
Bank does not change.
A setup of "Bank Hold" function is considered to be the cause. This is a very convenient function, when using only one bank in your performance. When unnecessary, please turn off "Bank Hold" function.
Patches do not change.
If display is blinking, when changing patches, "Direct Load" function is turned on. Please turn it off, referring to "Reserving the next Patch (Direct Lad) " in operation manual.
Effects, such as "Wah" using expression pedal, do not start.
Expression pedal operates also as an on/off switch for assigned effect by stepping on. Please step on ahead more strong. Refer to "Adjusting the expression pedal" in operation manual.
When connecting with guitar amplifier, unclear sound can be heard.
Two causes can be considered: Because of setup of "EQ" or "Amp Simulator"
1. Please raise the parameter "High" by setup equalizer.
2. Please set the knob "AMP SIM" at off.
The Sampler function cannot be used.
Please check operation, connection and output level of the playback equipment (CD player etc) of sound source to sample. Also, volume must become too small when the connection cable is "with resistor" type. Please use "no resistor" type cable.
Every time I change the patches on the GFX-707, even if I turn the amp simulator dial to off, amp simulator changes back to select "AP".
Amp Simulator is independent function on the GFX-707. You cannot store the parameter to each patch programs. It means "Amp simulator is always on or off" even you change the patches.
